Clcustomz 0 Posted October 6, 2011 i have tried using inkscape but can not get this to be even close i tried alot either i dont know what im doing or dont know how to thank you in advance Share this post Link to post Share on other sites
Clcustomz 0 Posted October 6, 2011 either sbd or eps will do thanks again Share this post Link to post Share on other sites
mark-s 1,126 Posted October 6, 2011 Bad image to start with. mark-s Share this post Link to post Share on other sites
Clcustomz 0 Posted October 7, 2011 Bad image to start with. mark-s Share this post Link to post Share on other sites
Clcustomz 0 Posted October 7, 2011 I know really bad but that's what the customer gave me and the only programs I have right now is inkscape and Sb have not figured out how to redraw it in inkscape Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted October 7, 2011 hire it out, drakesis is a member here, just a thought http://www.excaliburcreations.com Share this post Link to post Share on other sites
krautstyle 0 Posted October 17, 2011 I know really bad but that's what the customer gave me and the only programs I have right now is inkscape and Sb have not figured out how to redraw it in inkscape This will need some FINE Tuning. My opinion is start over for them. Florida Gator? Cutting torch and pliers? (Im Guessing) But heres a VERY Quick starting point? If its too bad I will stop trying Have fun ! gator welder.eps Share this post Link to post Share on other sites
vinylmotivations 143 Posted October 17, 2011 I was looking for information to contact, at the time forgot it was Drakesis, but needed some artwork vectorized NOW... and I did not have time to do it... I used vectordoctor.com and the guy there, I believe is here on the forums as well- he did an awesome job with relatively quick turnaround. Share this post Link to post Share on other sites
mark-s 1,126 Posted October 17, 2011 I think he`s hold a cutting tourch and calipers. mark-s Share this post Link to post Share on other sites
krautstyle 0 Posted October 17, 2011 I think he`s hold a cutting tourch and calipers. mark-s I was close Share this post Link to post Share on other sites
Clcustomz 0 Posted October 18, 2011 thanks kraut style I will look at it tonight and yes it's a torch and dial calipers its for a machine shop here in nola Share this post Link to post Share on other sites