rustyflakes 0 Posted August 30, 2011 Hi, I need some help with my UScutter MH-871 When trying to cut letters (1 inch), it wont cut them complete, the cutter is leaving a little space in each letter with out closing the complete letter. why is this? i tried reducing and giving it more speed. lowering and giving more pressure and it is still leaving gaps. can some one help me? my pressure is 140 and the speed i always use is 40 i am using green star vinyl thank you can you share your settings with me?! regards, Share this post Link to post Share on other sites
mb20music 760 Posted August 30, 2011 Sounds like an offset issue, what software are you using? Share this post Link to post Share on other sites
rustyflakes 0 Posted August 30, 2011 Sign Blaster, Trial mode. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted August 30, 2011 In Sign Blazer, you can adjust the blade offset. work with - or +.05mm until you get a good cut, If it gets worse going one direction, go back the other direction, make sure the blade is barely out. 2 Share this post Link to post Share on other sites
mb20music 760 Posted August 30, 2011 blade offset should be around .25 in SignBlazer Share this post Link to post Share on other sites
