Jeff_Kelly 0 Posted June 23, 2011 I need help!! Last night I was cutting with a Creation 1200 and using Signblazer software they were acting a little weird but would communicate and cut, after two cuts they stopped!! the plotter is on line and the software has the cut screen come up like its sending to the plotter but nothing. I have replaced the cord and had the computer cleaned up still nothing!! any ideas? Share this post Link to post Share on other sites
eddieb378 41 Posted June 23, 2011 In signblazer go to your cut screen and click setup. Under output device make sure you are set on the right communication port. If thats not it right under that is a comm settings button. Click on that and make sure your baud rate maches whats on your cutter. Hope this helps. Eddie Share this post Link to post Share on other sites
arty-rc 719 Posted June 23, 2011 Sometimes when my units won't communicate when I know everything is correct, I un-plug the USB cable and re-plug it. Works fine after that. Go figure? Share this post Link to post Share on other sites
