twicoin 2 Posted January 23, 2008 I haven't had any troubles with my cutter until the other day. Now when I send a cut job (I co right from Corel) it goes to que and I have to restart my computer for it to cut. It only cuts one job than I have to restart computer all over again. :help: I have gone to printer settings and tried refresh, restart, etc with no luck. :crash: I have Win XP. Any suggestions? Thanks in advance Share this post Link to post Share on other sites
kenimes 42 Posted January 23, 2008 Have you tried deleting the setup and setting it back up again? Are you using the included Serial to USB cable, or the LPT cable? Share this post Link to post Share on other sites
twicoin 2 Posted January 23, 2008 Ken I am using the cable and drivers that I got with the cutter and downloaded here. I haven't had any troubles until the other day. Not sure what to think. I have deleted the set up and created a new one and that didn't work. Any other ideas? Thanks for your help. Terry Share this post Link to post Share on other sites
kenimes 42 Posted January 23, 2008 Crud, no. I have no idea. I would suggest trying the cutter with SignBlazer or SignCut, and if it acts up with another program, it could be the cutter or cable. If not, it might be Corel or the setup. Share this post Link to post Share on other sites
espy 0 Posted January 29, 2008 Did you do a system restore....sounds like something might have gotten messed up in settings, or buffer. Share this post Link to post Share on other sites
