maddogsrfr81 0 Posted February 28, 2011 I am a newb, having a total of 48 hours working with my machine and adjusting to signcut, SBE, and using inkscape to vectorize graphics. I need to be able to print this image 1inch tall by the proportional width. Everything works fine but the .com at the end. I thought about cutting the .com and making it the same size, but that isn't his logo. I have a pcut 630, using the 45 blades that came with it and took his logo and used inkscape to convert it. Thanks in advance. Share this post Link to post Share on other sites
Jay2703 704 Posted February 28, 2011 Can you attach the image? Share this post Link to post Share on other sites
maddogsrfr81 0 Posted February 28, 2011 halo4.eps sorry, attached. Share this post Link to post Share on other sites
prototype66 20 Posted February 28, 2011 sometimes my cutter stops just short of cutting the entire image because I didnt leave enough material for the machine to hold and cut (lenth wise cuts) ....im a newb too and make these mistakes once in a while when I get in a hurry. Share this post Link to post Share on other sites
maddogsrfr81 0 Posted February 28, 2011 It tried to cut. It just didn't like .com after cut... Share this post Link to post Share on other sites