Steel546 0 Posted October 29, 2010 So I've had my EcoCut for less than a month now, and it's starting to piss me off. It would work great for some things, not so great for others. Sometimes the cutter will go over my image twice, or I'll cut one thing in decal vinyl then throw some easyweed in there and it'll stop halfway through. Not to mention, it cut up a whole yard of vinyl when all I needed was a few 24" bars and it never lifted it's blade. Anyways, I heard that instead of using SignCut, I could try SignBlazer. Well, everytime I try to install, it doesn't work. The closest I've gotten so far is when I hit cut, it'll tell me I have one document waiting to print instead of going to the cutter. I've gone through the Noob-V4.9 pdf over and over and I can't figure it out. Ideas? I've done some cool things with this cutter, but I really want to fix this for good. Thanks! Using XP 32-bit, Illustrator CS2 Share this post Link to post Share on other sites
Steel546 0 Posted October 29, 2010 Alright, I got it working. It'd be great if I changed it to the right CH431 USB port, but I still have some kinks. Share this post Link to post Share on other sites