jmatson 2 Posted September 25, 2010 is there a setting in the software. after it's done doing a single cut it would go to the end of that cut? Just like it goes for multi cuts. Share this post Link to post Share on other sites
hockeygirl 30 Posted September 26, 2010 What cutter? If you have a uscutter select refine as your cutter. Share this post Link to post Share on other sites
jmatson 2 Posted September 26, 2010 Pcut 630 currently that option is grayed out. Share this post Link to post Share on other sites
CRD 9 Posted October 1, 2010 I sold my Pcut. Your correct when you choose a Creation Pcut the option is greyed out. Paco Share this post Link to post Share on other sites
