G-Pete 0 Posted August 29, 2010 Hi Guys, My equipment: MH871 36 inch, Corel Draw X4, FlexiStarter 8.6 V2, Dell GX 620 1G Graph 4G Mem, serial connection to cutter and grounded. My problem: After the cut the knife lifts not up and go to the beginning position (orgin) I have to press the reset button. This happens every time. The cutter just cut fine until 2 weeks ago. The second problem does not occur that often - there are strange lines in the object. These are not double lines forgotten in the original drawing because I cut the same project without problems before. My files are not large and complicated Any thoughts? thank you! Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted September 3, 2010 what does tech support say about it? Share this post Link to post Share on other sites
G-Pete 0 Posted September 6, 2010 My first thought was to try it here - got plenty of ideas and tips of this website. I will call them tomorrow and let you guys know if something comes up --- thanks Share this post Link to post Share on other sites