emjball 0 Posted July 6, 2010 Complete newbie here and am sooo thankful for this board and the people on it I've been cutting stuff mostly to get down how it works. I've noticed on a few things I cut, usually smaller letters that the vinyl starts peeling away while it's still getting cut....I thought maybe it was speed so I slowed it down and it is still doing it....Any thoughts on what I'm doing wrong?? Thanks for any input! Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted July 6, 2010 it can depend on what type of vinyl you are using.. Cheap vinyls can do that. and how far your blade is sticking out. Only needs to barely be seen sticking out of the holder. and yes, run slower can help too. Share this post Link to post Share on other sites
emjball 0 Posted July 6, 2010 I'm using some stuff I got off Ebay, which I'm guessing is pretty cheap. I'll try resetting the blade and see if that helps. Thanks for the tips Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted July 6, 2010 get some good vinyl for orders. will probably take care of the problem.. just use cheap for practice. Your welcome Share this post Link to post Share on other sites
prestonservco 26 Posted July 9, 2010 Sometimes a piece of vinyl gets stuck in the blade holder and drags around peeling up things. Share this post Link to post Share on other sites