thredz 1 Posted February 24, 2007 When I set the cp-2500 up in signcut,I was having problems between communication to the lpt port.I went to the copam sites download section and downloaded the win2000 driver.I unrared it to a folder I named copam2500,then I went to the start bar in windows and clicked on the printers and faxes - add new printer.I chose not to do a search and clicked on have disk.When I went to browse,I went to the copam2500 folder and it shows - cutt.inf .I clicked on it and it showed an icon with letters cutter.I then went into signcut - settings - cutter -and under device when I clicked it,it brought up all of the available ports to use.One of them is letters cutter instead of lpt1.After that I have had no problems cutting in signcut.I have posted the link to the download site below. http://www.copam-electronic.com/en/copam%5Fdownload/ Share this post Link to post Share on other sites
backbone18 0 Posted November 13, 2008 Thank alot the info. Hope it usefull. Share this post Link to post Share on other sites