Actualgrafix 0 Posted April 18, 2010 I have had the copam for a few years now and it works fantastic. The only complaint i have is that each time i cut,i have to manually measure the width of the vinyl then type it in to Flexi. Can the Copam send it's measurements directly to Flexi? I am using XP with the serial cable. Share this post Link to post Share on other sites
Actualgrafix 0 Posted April 23, 2010 Anyone? Anyone at all? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 23, 2010 Why are you measuring the width all the time? maybe explain more. I leave my Flexi 8.6 on 29.6"x 1968" (the highest numbers) all the time. my cutter is 30" Graphtec and also did the same with my 30" Seiki, unless I want to run multiples on something more smaller and narrower.. But even if its a 6" wide piece I put in, and just run a single decal on it. I don't have to change the Flexi vinyl width. and I leave my workspace set at Architecture D all the time. Share this post Link to post Share on other sites
Actualgrafix 0 Posted May 6, 2010 i use anywhere from 6" wide to 48" wide vinyl. WHen i press the measure button on the plotter it measures it but doesn't relay the information to the computer. Know what i mean? What is architecture D? Share this post Link to post Share on other sites