martymoe 0 Posted December 6, 2007 i have a pcut and signblazer. i use corel 12 for my drawings and just copy and paste them into signblazer as someone suggested. on problem i'm having is the machine is cutting each line twice.. does anybody know why or how to make it stop doing that? what am i doing wrong.. thanks.. Share this post Link to post Share on other sites
firemalt 10 Posted December 6, 2007 Is the image layered? Share this post Link to post Share on other sites
Bruce SignBlazer Support 0 Posted December 6, 2007 Can you try a simple test of just a rectangle in CorelDraw. Then try cutting in SignBlazer. If that cuts twice, can you please upload the cdr file here and I'll have a look. Share this post Link to post Share on other sites
martymoe 0 Posted December 6, 2007 ok.. here are the steps i took created a new corel 12 doc. drew, drawed, drawen.. .... made a rectangle converted it to curves copied it to the clipboard switched to signblazer pasted it.. cut it.. it cut twice the same as the signs.. i dont know how to upload, here but i put the file up on my server so you can get to it.. goto http://house.martymoe.info/files it's the only file in there (testcut.cdr) thank you.. i hope you can figure out what i'm doing wrong.. m Share this post Link to post Share on other sites
Bruce SignBlazer Support 0 Posted December 6, 2007 I think it is because you have a pen width specified as well as a fill. Try setting the pen width to "None". Share this post Link to post Share on other sites
martymoe 0 Posted December 6, 2007 i've only ever used corel for my plasma machine which uses plt files and my milling machine which uses dxf. i normally push the x (in the colors) which i thought was get rid of fill. if i turnoff outlines i cant see the part anymore.. how do the rest of you who use corel normally send your vector graphics to signblazer? Share this post Link to post Share on other sites