pyrophire 0 Posted April 6, 2010 K so I got my samples of mactac and its a tight roll... I have an Epson 1100 that I'll use for the printing but its rather picky about feeding in pages. What is the easiest/best way to flatten the vinyl out. I've cut some strips down and rolled it in the opposite direction but the edges still keep rolling up. Share this post Link to post Share on other sites
cohort 0 Posted April 7, 2010 Stick them between a flat table and a heavy board for a while, but don't take it out until you're ready to use it, because after a bit it will curl again. Share this post Link to post Share on other sites