mod22 0 Posted April 2, 2010 Not a problem but a question . It has two drive rollers close together on the right when facing the machine but it will only let me slide 1 pinch roller over that far is there something special I have to do to get two pinch rollers over there or will it not work that way ? It would be great to cut small scraps . Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 2, 2010 my Graphtec is the same way. See if there is a screw in the back that they are using as a stopper for the pinch roller, I keep a screw driver on top my machine just for that. I can loosen the screw and it is in a little piece of metal that slides either way in a slot/track. So I can bring both pinch rollers right together to do little 2- 3" wide pieces. Share this post Link to post Share on other sites
mod22 0 Posted April 2, 2010 Thanks I will check that out when I get home. why would they put a stopper there ? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 2, 2010 sorry I don't design them. LOL I have no idea, I just know how to get around it. Like I said, I have alot of scrap, So I use what I can. Share this post Link to post Share on other sites
mod22 0 Posted April 2, 2010 Well you probably could and if not you would make a great consultant I know your knowledge has helped me a few times already .Again thanks for all the help. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 2, 2010 your welcome and thanks for the compliment, This ol' gal will always accept those. Share this post Link to post Share on other sites