blownchevyII 0 Posted January 30, 2010 Does anyone have a vectorized circle with a slash through it? Share this post Link to post Share on other sites
blownchevyII 0 Posted January 30, 2010 oopps sorry...wrong section. Mods please move this Share this post Link to post Share on other sites
sarconastic 29 Posted February 1, 2010 that is the simplest symbol to make ever. just create a circle, then a smaller circle in a different color adjust it to the thickness of outer circle you want.Select both circle. Use the weld cutout function of your software to remove the center. then create a rectangle the same width as your circle and the same width as your outer line, and rotate it ti 45 degrees, place it over your circle. select the circle and the rectangle and weld them together. wallah you not have the NO symbol. Kevin Share this post Link to post Share on other sites
Jay2703 704 Posted February 1, 2010 If you have SignBlazer it can be found in the library. Draw + Library then select the Category "Signs" then Amenities from the column on the left. It is towards the bottom. Jay Share this post Link to post Share on other sites
MaderDesign 3 Posted February 1, 2010 if you can't draw this in Illustrator/signblazer/flexi then your in for a world of hurt. sorry Share this post Link to post Share on other sites
