bmsignworks 0 Posted January 25, 2010 ok i bought the laserpoint to do the contour cutting. i adjusted the cut doing the 1" square box yesterday and got it with a 1/16 inch. close enough for me. then i accidently deleted the laser point out of the production manager in flexi. no big deal. reinstalled the cutting in production manager. loaded a simple contour cut file (fluer de lis)to check it and it seem to go back to about where i started adjusting from the first point. did i miss something or will i have to go and start the process over again with the box lineing it up. thanks brad Share this post Link to post Share on other sites
bmsignworks 0 Posted January 26, 2010 i got it. had to redo the measurements again. but i have got it now. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted January 26, 2010 good deal - glad you got it worked out Share this post Link to post Share on other sites