Kelly54487 2 Posted October 8, 2009 Ok this is my problem I have a design layout I made up for our school. There going to be decals but....... when I go to cut my image some letters are higher then the others??? It looks FINE on the screen till I get to the cut screen? Any suggestions why this is doing this? Regards, Kelly Share this post Link to post Share on other sites
mr300s 1,272 Posted October 8, 2009 not sure have you tried to weld all the letters? Go to arrange then to weld then total weld? Share this post Link to post Share on other sites
YadirellT 0 Posted October 8, 2009 I've actually seen this a few times myself. If it's looking different on the cut screen, make sure that you don't have some layers turned off. If your using Signblazer, you can find this in the upper left hand window on the cut screen. To enable several layers at the same time, hold down the Ctrl key, and click on the layers that are 'X'd out. Let us know if that doesn't help. Share this post Link to post Share on other sites
Kelly54487 2 Posted October 8, 2009 Yes I've done this already and still no luck. Share this post Link to post Share on other sites
sarconastic 29 Posted October 8, 2009 make sure your don't have anything checked under the Save Space tab in your cutter screen. this will do all kinds of weird rearranging of your graphics. Kevin Share this post Link to post Share on other sites
Kelly54487 2 Posted October 8, 2009 Kevin, Thanks this fixed the problem Thanks so much ah I feel so much better. Always something to learn. Share this post Link to post Share on other sites
sarconastic 29 Posted October 8, 2009 glad to help. The only reason i knew the answer is because I had the same issue LOL kevin Share this post Link to post Share on other sites