pitts-s1s-pilot 0 Posted September 1, 2009 Group, Copam running SBE. I have a sign 4' by 16' and want to cut two 8' tiles instead of a single 16' monster. (I'm trying to avoid tracking/runout/application problems.) Under set up I set the vinyl size to 24" by 97" and it automatically tiled it in two pieces. When I hit cut it highlights tile number one but then cuts number two. What am I doing wrong? Thanks, Pitts Share this post Link to post Share on other sites
Jay2703 704 Posted September 2, 2009 What tile number does it say in the upper right corner to cut next. Does it highlight in Red? Jay Share this post Link to post Share on other sites
pitts-s1s-pilot 0 Posted September 2, 2009 The problem has cured itself by shutting the program down and restarting. I don't know if I did something wrong or what. I was able to finish my sign with minimal waste though. Thanks Share this post Link to post Share on other sites
Jay2703 704 Posted September 2, 2009 Good to hear. Jay Share this post Link to post Share on other sites