vgiex 0 Posted August 11, 2009 Hi first of all LaserPoint cutter is my second one. My first one is the Pcut series. I had some problems with Pcut but nothing major like the LaserPoint. 1. Three screws are missing from the left of the inner wall. I don't think it is normal. I finally found the vibrating noise. 2. Cracked blade holder ring. I noticed after I loosen the screw to replace the blade. It never happen to Pcut. Is this replacesable? 3. Cutting while the blade was on up mode and skip the cut. What is the problem. offset is fine. pressure is fine. We been using this for 2 months now and it just happened. Is this because for the holder ring or something else? I might be overlooked some details but settings I think are not the problem. Share this post Link to post Share on other sites
haumana 1,220 Posted August 11, 2009 huh? You should submit this to the LP Support bulleting, and/or send an email directly to USC so they can get it fixed up for you. Share this post Link to post Share on other sites