bamafan2277 50 Posted July 28, 2009 I just purchased a 630NOS from UScutter on ebay. I want to order some extra blades to have on had. What does everyone recommend for this cutter? I noticed there are several types. Also will this cutter cut roll magnets down? If so what blades do I need for that? Thanks in advance!! Share this post Link to post Share on other sites
jhelms 5 Posted July 30, 2009 I cut specialty magnets with my pcut i adjust preesure up 6 to 8 and run my machine as slow as it will go I use old 60 degree blades to cut them it will not cut all the way but all you have to do is just pop it out and also I do lots of small decals so I just run 60 degree blades all the time jhelms Share this post Link to post Share on other sites
bamafan2277 50 Posted July 31, 2009 Thanks for the information. I won a 30pcs of 45 Share this post Link to post Share on other sites
bamafan2277 50 Posted July 31, 2009 I plan on doing a lot of cutting at first to learn all the little tricks just playing around. I ordered some vinyl off eBay and got it yesterday and it was not the best. the seller agreed to send me some more for free so I figure I got a lot of cheap vinyl to play around with and once I got the technique down I will do the quality stuff. Share this post Link to post Share on other sites
