guffman 0 Posted October 9, 2007 New here and never used a plotter before. Checked the com port and baud rate but still will not work. Can someone help me out please. Thanks. Mike Share this post Link to post Share on other sites
tservice 3 Posted October 9, 2007 Did you check the buad rate on the cutter its self and compare to software? Are you using SBE? Share this post Link to post Share on other sites
tservice 3 Posted October 9, 2007 this post may help http://forum.uscutter.com/index.php?topic=1602.0 Share this post Link to post Share on other sites
kenimes 42 Posted October 9, 2007 Make sure the cutter says Online, and that the carriage is not pressing either of the red buttons. Share this post Link to post Share on other sites