mceachj1 0 Posted July 20, 2009 new to this. Cutting a 6 foot sign when it was almost done it stopped and says waiting on the led. What is going on? it is a creation p-cut. thanks Share this post Link to post Share on other sites
MGOMEZ 0 Posted July 20, 2009 not sure what the problem could be. try replacing the cable if you are using usb. some of the other guys will know what to do if that dosn't help. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted July 20, 2009 what cutting software are you using? Signblazer? Flexistarter? etc? Share this post Link to post Share on other sites
Guest sciondrgn Posted July 21, 2009 Did the carriage get to close to the sides and hit one of the red buttons? If so then turn the unit off, Manually move the carriage off the button and turn the unit back on Share this post Link to post Share on other sites
