bwlee 0 Posted July 14, 2009 Got a odd issue here.. My cutter seems to be cutting too deep in the beginning and end of every group of points on the vector graphic or letter. The rest cuts fine but just the initial and ending points are piercing thru the backing. I've changed the depth & pressure settings to no avail.. Share this post Link to post Share on other sites
kenimes 42 Posted July 15, 2009 What is the highest pressure setting you have tried? Share this post Link to post Share on other sites
bwlee 0 Posted July 15, 2009 I got it fixed I think.. Didn't bother to check the blade, noticed it was sticking out a little more than I liked, redid the blade depth and it seems to be fine, though I did put a new blade in place in too so maybe its related. Share this post Link to post Share on other sites
kenimes 42 Posted July 15, 2009 Yea, you should hardly be able to see just the very tip of the blade exposed from the blade holder. Share this post Link to post Share on other sites
repodon 1 Posted July 25, 2009 ken imes i sent you a private email havent heard from you can you email me thanks Share this post Link to post Share on other sites