Guest SignCorpUSA Posted September 28, 2007 I am new to this. If I buy Corel X3 and SignCut X-2, will they work together with the US Cutter Refine MH721? I need a one stop solution. Share this post Link to post Share on other sites
edge 67 Posted September 30, 2007 While I have the Copam rather than the Refine. I design in Corel X3 and launch the SignCut directly from the X3 to cut without any hitches. Share this post Link to post Share on other sites
Guest SignCorpUSA Posted September 30, 2007 I bought Corel X3 and am usind the 5 day demo of SC-X2. Problem I am having is when I send from X3 to SC nothing show up in SC. Some files I send only put a line. I can send the same file from Illistrator CS2 and it goes fine. Any Ideas? Share this post Link to post Share on other sites
dgreenh 9 Posted October 1, 2007 I launch Signcut X2 directly from CorelDraw X3 using the Refine Cutter and it has worked flawlessly every time. I'm not sure why it isn't working for you. Here is how I do it... I design the graphic in CorelDraw Launch SignIt-X2 using the the application launcher in Corel (The little rocket in the tool bar) Then I click on the cutter blade looking icon in the SignIt X2 tool bar. SignCut opens and my graphic is there ready to cut. Share this post Link to post Share on other sites
Guest SignCorpUSA Posted October 1, 2007 Thanks - The rocket works for me too. I was going to FILE -> SENT TO and that is not working. I talked with tech supp for SC and the recommended a reinstall to fix the broken link. Share this post Link to post Share on other sites
hotrodrichie 0 Posted January 27, 2008 They work very well togather its all i use Share this post Link to post Share on other sites