mikejr1212 0 Posted June 13, 2009 I HAVE BEEN AT THIS FOR HOURS. NOW I GET THE PORT WORKING AND THE CUTTING BLADE IS RIPPING IT APART TRIED TO LEAVE ONLY A LITTLE AS BUT STILL THE SAME. HELP HELP HELP PLEASE Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted June 13, 2009 raise your blade, until just barely sticking out of the holder, and lower the force.....start with just doing a test and not any type of design.. AND take a deep breath, it does get easier,, Share this post Link to post Share on other sites
mikejr1212 0 Posted June 13, 2009 THANKS THAT WORKED OK NOW IT FINISHES CUTTING BUT STILL SAYS CUTTING AND THE BLADE IS DOWN. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted June 13, 2009 I only know about Flexi starter, I do not know about your machine, I have a totally different machine that is not a US cutter product...possibly some one else can help you on your machine.. Share this post Link to post Share on other sites
Guest Posted June 16, 2009 It finishes the cut and then locks up? This is strange, generally if there is a lock up it will happen in the middle of the cut, not after it is finished. This may be caused by some software settings. If this continues please shoot me a PM with a good time to give you a call so I can log into your computer. Share this post Link to post Share on other sites
mikejr1212 0 Posted June 19, 2009 TY all For all the help. Share this post Link to post Share on other sites
Guest Posted June 25, 2009 So was the lock up problem resolved? Share this post Link to post Share on other sites