roketa36 0 Posted May 25, 2009 Here is a Turbine Jet that I did. I did the Ford logos, Zap logos and the Team Futaba logos. It flew as a demo plane at the worlds larges scale r/c plane meet by a world famous pilot. I had my vinyl cutter at the meet set-up in my trailer and he came over to have the work done. I guess I will have to put a picture of this up in the vinyl trailer lol. This plane can reach speeds of 200+ mph Share this post Link to post Share on other sites
sandman 5 Posted May 25, 2009 That is cool as all gettout. NICE WORK! At 200 mph I bet it could get out of range of the controller before you could say "don't do it". Share this post Link to post Share on other sites
Guest kenya Posted May 25, 2009 GREAT JOB Hope that's 200+ mph vinyl - Share this post Link to post Share on other sites
roketa36 0 Posted May 25, 2009 Yeah they can get away from you real quick. You need a special permit to fly one of those things. That one is in the 20-30k range as far as price goes but They have some that cost up to 50k+. These guys are just sick I saw a few of the real high dollar ones hit the ground that weekend. I was praying this one didn't. I was cutting the vinyl while the guys where putting it on. I have to say that I was glad to not have to install it due to the price. but there were to many bubbles for my liking. But it held up at over 200+ mph. BTW the vinyl was both intermediate and the low cost vinyl. Just though you guys would enjoy this. Tom Share this post Link to post Share on other sites