Guest crshirts Posted May 24, 2009 Is there a setting I am missing to stop feed after cutting? Carl Share this post Link to post Share on other sites
edge 67 Posted May 25, 2009 Using ver 2.21. Goto Settings > Cutter. In the lower right side of window "Forward feed after cutting" and below that will be "Rewind after forward feed". Mine is default @ 5.906 and 4.724 respectfully. Hope this helps. Share this post Link to post Share on other sites
Guest crshirts Posted May 25, 2009 Tried setting them to zero and still feeds after finished. Carl Share this post Link to post Share on other sites
edge 67 Posted May 27, 2009 Tried setting them to zero and still feeds after finished.Carl What happens if you set the rewind after forward feed at a value just less than the forward feed value? Example: Forward feed value of 5.00, Rewind value of 4.85. Share this post Link to post Share on other sites
Guest crshirts Posted May 27, 2009 I'll try that tonight Thanks Carl Share this post Link to post Share on other sites
Guest crshirts Posted May 31, 2009 Well I finally cut the Flexistarter to work that came with cutter, so signcut is on hold for now even tho I like it. Carl Share this post Link to post Share on other sites