rfhuber 0 Posted September 7, 2007 New to this game and wondered what the correlation was, if any, of cutting tip angle to material? Why would I have different angles? Is wear a factor or what? Anyway would appreciate any input. Thanks! Rick H Share this post Link to post Share on other sites
kenimes 42 Posted September 7, 2007 The 45degree angle blades that you receive with your cutter will cut most vinyl. For thicker material, like sandblast mask, stencil board, etc. you would use a 60degree blade which has a sharper angle. Share this post Link to post Share on other sites
rfhuber 0 Posted September 7, 2007 Thanks for the response. I am cutting chrome polyester Oracal 351 1 mil. I assume then the 45's I received with my 2500 are good to go. Rick H Share this post Link to post Share on other sites
kenimes 42 Posted September 7, 2007 Yup- good to go. Share this post Link to post Share on other sites