DanRHeller 1 Posted May 6, 2009 When I cut a certain file, I get a random cut through the letter U, that removes a large chunk of it, and I don't know why? Any ideas? I would attach the file, but it says it is too large. And I don't know how to change it. Share this post Link to post Share on other sites
JoeBlow 5 Posted May 6, 2009 I would check your graphic for "Open Paths". Share this post Link to post Share on other sites
DanRHeller 1 Posted May 6, 2009 I don't see any open paths. I pen tooled all the way around all the letters originally to get points for it to cut, and they all seem fine. Share this post Link to post Share on other sites
Kimon 1 Posted May 7, 2009 What type of plotter? What cutting software? How about uploading a file? Share this post Link to post Share on other sites
jeremySI 18 Posted May 7, 2009 send the image to jeremy0203@aol.com and lemme take a look at it Share this post Link to post Share on other sites
DanRHeller 1 Posted May 7, 2009 Laserpoint 24 and SB. Jeremy, email was sent. Share this post Link to post Share on other sites
DanRHeller 1 Posted May 7, 2009 Did you look at the file in wire frame? You may have a stray object or line in the background. Just a thought. I don't know how to do that. Jeremy, I don't see that on mine at all. Share this post Link to post Share on other sites
Mr Peabody 0 Posted May 7, 2009 Sorry but I'm not using SB... Share this post Link to post Share on other sites
Mr Peabody 0 Posted May 7, 2009 Did you look at the file in wire frame? You may have a stray object or line in the background. Just a thought. Share this post Link to post Share on other sites
jeremySI 18 Posted May 7, 2009 maybe its my program but why do some of the letters have two of the same letter sitting on top of each other? Share this post Link to post Share on other sites
jeremySI 18 Posted May 7, 2009 in SB go to the view tab and select wireframe when i select certain letters and drag them away there is another one of the same letter underneath it and a couple letters there is not Share this post Link to post Share on other sites
DanRHeller 1 Posted May 7, 2009 The image looks fine until I hit the node edit key and then the U changes to how it cuts......Why would it do that/how do I fix it? Share this post Link to post Share on other sites
jeremySI 18 Posted May 7, 2009 i cant even get your image to open in SB Share this post Link to post Share on other sites
DanRHeller 1 Posted May 8, 2009 Hmmmm. I emailed you a second one, it is in .SBD and should come up wireframed. Share this post Link to post Share on other sites
jeremySI 18 Posted May 8, 2009 check your email, i sent you one that cut fine Share this post Link to post Share on other sites
DanRHeller 1 Posted May 8, 2009 Thanks a ton! I'm gunna go try it out in a few. Share this post Link to post Share on other sites