oates 0 Posted April 26, 2009 I have an enclosed trailer with lots of screw heads on the side, should I take the screws out or out the vinyl over top and poke holes around the head. Share this post Link to post Share on other sites
firemalt 10 Posted April 27, 2009 Are the screw heads rounded, or bolts/hex heads? If they are rounded, just use a cast vinyl, and it will conform around them. Share this post Link to post Share on other sites
mabscotthandyman 1,410 Posted April 27, 2009 you can also order a stippling brush from one of the suppliers. i don't know if us cutter has them or not. but look in tolls on the web sites difficult ones may need a little heat as you work them. dan Share this post Link to post Share on other sites
cutme 5 Posted April 27, 2009 you could get one of these handy gadgets... bb Share this post Link to post Share on other sites
oates 0 Posted April 28, 2009 thanks for all of your information. Share this post Link to post Share on other sites
Guest round2racing Posted April 30, 2009 Also, check out the "rivets" posting. There are some great techniques there, including one with a tennis ball. Share this post Link to post Share on other sites
Guest Schramm Posted May 1, 2009 Just use a hairdryer and a rivot brush, you can get a 1" one for about $10 Share this post Link to post Share on other sites
