Jason50 1 Posted August 16, 2007 Which driver can i use for the cp 2500. i have installed several including: HPGL/2, PNC 1000, PNC 1000A, PNC 960, PNC 950... HPGL/2 make the plotter move about an inch, but the other simply do nothing in regard to the plotter. the printer icon appears just long enough for the file to "load" into the "printer properties dialogue box" and then nothing. thanks Share this post Link to post Share on other sites
kenimes 42 Posted August 16, 2007 Jason50 is using Dr. Stika software......anybody had success in getting the CP-2500 to run with this software? Share this post Link to post Share on other sites
Jason50 1 Posted August 16, 2007 by customer do you mean me or someone else? i use the dr stika program to operate my graphtec daily, but am unable to make the copam do anything in regards to the dr stika program. i will attempt to install the roland cutchoice program and see if that helps any. thanks Share this post Link to post Share on other sites
kenimes 42 Posted August 16, 2007 I meant you, and edited to make it clear. Hope someone has some input. Share this post Link to post Share on other sites
Jason50 1 Posted August 17, 2007 yes any help would be great! i am pming "atom" here on the forum he stated he had success with dr stika kimon w/ signforums said he would spend a little time with it aswell. thanks jason50 Share this post Link to post Share on other sites
Jason50 1 Posted August 17, 2007 i figured it out :) :o :o :o i said i figured it out!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! just download the sv sx stx driver here http://www.rolanddga.com/color/support/wizard/default.asp?mt=359 this should be added as a bundled driver, the find saved me alot of time and money thanks ken and "atom" Share this post Link to post Share on other sites
