CES 0 Posted July 20, 2007 I'm getting some sort of vibration while cutting and that vibration causes the blade to skip cutting all the way through. It mainly happens when it's cutting in both axis, like on a "W" or "Y". I've tried a brand new blade, slowed the speed all the way down, and increased and decreased cutting pressure. Nothing seems to make the vibration go away. It's a loud noise when it happens, so it's not a silent vibration. It's a very loud chattering sound that happens. When the noise happens, the vinyl cut quality immediately reflects it, telling me it's some sort of vibration. Any tips? I'm in a jam right now with a fair amount of vinyl work to do. Share this post Link to post Share on other sites
kenimes 42 Posted July 20, 2007 You could loosen the material off of the roll before feeding into the cutter, instead of having the cutter pull from a tight roll of material. Have not heard of this one before, so not sure what to check. Did this just start happening, or has it always done this? It could also be a bad file you are trying to cut. Could you post the file so I might be able to test it out? Share this post Link to post Share on other sites
