randyb 1 Posted January 4, 2009 I turned my force down to 80 and made 1 small cut and it worked fine.Went to cut another and got no responce?Nothing happened?I restarted my PC and turned force back to 100 and it seems fine? Any ideas what happened?Should i just leave at 100 all the time???;D?? Share this post Link to post Share on other sites
Rodger 527 Posted January 4, 2009 Did you try cutting after restarting the pc , but before adjusting the force back up In anything , always change/do 1 thing at a time , that way you determine if/how that effected anything . Adjusting the force should only effect how it cuts , not if it cuts . It is a combination with the blade setting , but not enough downforce , the vinyl wont be cut thru to the backing paper & hard to weed , especially with specialty vinyl . Too much & I'm guessing cutting into or thru the backing paper & marring the vinyl with the blade holder . Share this post Link to post Share on other sites
