pitkin2020 1 Posted April 15, 2010 I just used rectangle reg. marks and after i app. tape them, i cut the tape off right around the reg. marks. You just like up the 2 edges of the rectangles. I hope that made some sense. I use a similar method, I use square/rectangle reg mark, tape it then with a scapel i cut out through the app tape cutting out the square/rectangle leaving a nice little window to line up the reg marks on the bottom layer. Share this post Link to post Share on other sites
mopar691 281 Posted April 15, 2010 i actually dug out my light table last weekend but still not clear enough to make a definite layover, good for simple text layovers but more complex stuff just no definition there. The clear tape is the best idea for me and its fast and easy. 1 Share this post Link to post Share on other sites
jhelms 5 Posted April 16, 2010 Do you know what is better than that look thru forum and find websites of suppliers to send you samples and your local suppliers will help also of a clear transfer tape between them I have plenty for that,also I take the unclear when doing vehicles and take registration marks and take a pencil and rub oround them and then pull off the ones on the tape and leave ones on vehicle and with your finger nails you can feel it and on this I wet apply and no problem and quicker for me hope this helps jhelms Share this post Link to post Share on other sites
kboyte 2 Posted May 1, 2010 thanks for the great tip!!!! very useful Kim Share this post Link to post Share on other sites
jebbie17 0 Posted May 31, 2010 I am new to the forum and still finding my way around Sign Blazer. I use Corel a lot but I am still trying to figure Sign Blazer out. To print registration marks, the instruction manual tells you to go to the print tool bar and click on the registration mark icon...in the version that came with my US Cutter MH721 it states that this version of sign blazer does not have registration marks. Does anyone know how to get the registration marks from Sign Blazer software or how to improvize and make them on the print? Any help would be appreciated. Thanks Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 31, 2010 there is no registration marks in Signblazer, you have to make your own, squares. circles, etc. On this post there is an .eps file you can download and use for your registation marks. http://forum.uscutter.com/index.php/topic,19281.0.html Share this post Link to post Share on other sites
76mark 0 Posted May 31, 2010 Thanks for the tip. I've been doing the same thing using clear app tape when I've wanted paper tape on the graphic. Using packing tape would be much quicker. Mark Share this post Link to post Share on other sites
dasfreak 1 Posted February 21, 2014 For those that want a cheap alternative to clear trasnfer tape should try GLAD PRESS-N-SEAL. I've used it with great success. http://www.amazon.com/Glad-Pressn-Seal-3-Pack/dp/B0025UV6JC Share this post Link to post Share on other sites