brewzer1818 0 Posted November 27, 2008 New owner. had wverything hooked up and running smoothly then tried to send a cut to cutter with it off line. Now I can't get it to come on line. have tried powering down restarting computer disconeting USB, unplugging. HELP! Share this post Link to post Share on other sites
SmokinZMan 2 Posted November 27, 2008 Make sure the cutter head is not all the way to one side, on each side there is a reset switch (little red button) if the head is against it it will not go online. HTH Bryan Share this post Link to post Share on other sites
brewzer1818 0 Posted November 27, 2008 taht was it thanks Share this post Link to post Share on other sites
Cashburn 0 Posted November 21, 2009 What if it will not come online and the head is in the center and nowhere near the red cutoff buttons? Share this post Link to post Share on other sites
bowhunter012004 4 Posted November 23, 2009 if it is off line, press the button in the middle of the arrow keys, to center the head, then press "on line" to put it on line. It wont cut anything unless the cutter is "on line" Share this post Link to post Share on other sites
Cashburn 0 Posted November 23, 2009 I should be more clear. It does not "boot up". I get the display to show the black rectangles and it does not go into the next step which would read Online or Offline if I press the button in the middle of the arrows. Share this post Link to post Share on other sites
Cashburn 0 Posted November 23, 2009 Also I have tried tapping the red kill buttons and that does not do it either. It worked fine for 4 months... Share this post Link to post Share on other sites