First let me say Hello!
I am a first time user and I have been cutting vinyl successfully for near six months and then my troubles just started out of the blue and I dont know why.
Here is what I have:
Cutter: MH 1351 I purchased from USCutter.com
Vinyl: I have been using rolls of Orafol and Greenstar vinyl.
Cutter is connected via USB cord to the computer
Computer: HP Windows 8
Cutting Software: Sure Cuts Alot 3 Pro
Drivers: USCutter support made sure I had the lastest drivers installed last week whenI called them about this problem.
Overcut: 1.10mm
Blade Offset: .38mm
The tech could not figure out why it is not closing the loop on my cuts. It is not leaving a gap to close as much as the cut is getting offset by the time I get to the end of the cut. I have attached an image that might help explain the issue.
I am missing out on sales because of this. Any help would be appreciated!!!!!
Thanks,
Mike