Hey guys. Excited to get involved in this forum and begin making contributions. I have a question however, I have found somewhat related topics but not exactly what I'm experiencing. Basically, I am having trouble with the blade height. I did all the tests on vinyl and paper. I also ran a test cut with paper and the pen tool. When I put the blade on and run the test shape, it seems like the blade isn't being picked up off the material when it shouldn't be cutting, basically, at the end of the cut, it drags back over the prior cuts. My pressure is set to 120g and when I set the blade, i made sure it could really only cut though a single piece of paper. To me it seems like an issue of how high the scroller is set itself, is there a way to calibrate that? Thanks so much, and i apologize if this isn't the correct place for this.