islandjay
Members-
Content Count
11 -
Joined
-
Last visited
Community Reputation
3 NeutralAbout islandjay
-
Rank
Member
-
That was it! It was the rollers. makes sense now. Live and learn. thanks!
-
They were set to zero. Still no luck. Appreciate the help so far
-
I tried both checked and unchecked. When I use 15" vinyl it is fine.
-
thanks!
-
islandjay started following Untitled 1
-
I appreciate the help, but no luck. It is starting 3" into the material and cutting off 3" at the end still Why would not not start near the edge? it is like it has a 3" left and right margin. Any other thoughts?
-
Yes, just as wide as the paper
-
I have a Copam 2500 and I am Sign Blazer. The vinyl is 24" wide and I tell the copam to measure before cutting. The cut job is 18" by 6", so naturally I set the 18" to cut wide. Every time is does not cut all the way. At best it goes 17" and stops the cut. Does not even finish it so half of the job is still attached to unwanted vinyl. If I rotate it 90 degrees, it cuts the whole thing. What am I missing? Thanks! Jason
-
Just called US Cutter and spoke to Dave. We isolated it down to a bad cable. Got one and I am up and running! Thanks!
-
Did not help. Appears to be a hardware issue. As mentioned it was cutting fine and just stopped. There no com ports in my device manager now, either. I did originally have it running through a USB hub and USB extension cable. I removed both after the problem and I have the same results. Is a parallel cable easier?
-
New to vinyl so bare with me please. I appreciate the help. basically I got a used Copam 2500. Installed the driver for a serial to usb connection. Downloaded SC pro. Cutting vinyl within 15 minutes and was for a few days. Then my SC pro software would free when I tell it to cut. Reboots, etc did not help for cutter or my win 7 pro 64bit pc. I uninstalled sc pro, rebooted. Reinstalled the serial to usb driver from cables to go. Followed these instructions http://forum.uscutter.com/index.php?/topic/207-copam-setup-instructions/ Same issue still. SC pro just freezes when I tell it to print the SC pro logo. Zero activity on the cutter What am I missing? Thanks! Jason PS - I clearly cannot spell today!