wijames

Great call!!! That was it. This is the first jam I have had so I guess I've been lucky. Thanks!

I didn't check that but I will tonight. You're talking about the carriage that holds the cutter?

I had a small jam and now my 721 cuts wavey letters. I adjusted the pressure on the tracking wheels and installed a new blade but nothing helped. Help!!!

No, I haven't yet but I will this weekend. Thanks

Where can I send the file to. I see I can only attach up to a 512 here and both of the files I'm having trouble with are 1Meg. Thanks Butch

Thanks so much for all the help. It's really appreciated. William

How do I do that exactly? Thanks use the pen in place of the knife and draw as big a square as you can draw on paper. measure it and compare your measurement to the drawing in your software. if it isn't correct, make adjustments to the x and y numbers on the display on your plotter. bb Thank you, I'll do that! mm

For some reason, that doesn't seem to work for me. I've tried several different designs but some part of it always looks and cut bad. I'm sure it's something I'm doing wrong but can't quite figure it out.

When I go through the "Postscript interpreter" it looks like it's going to import but doesn't show up.

I'm having trouble saving files in CS4 so they will import into Signblazer. I've tried several formats (IL, EPS, etc) with no success. I can do the same file in Inkscape and save it as an EPS. and it imports fine. Has anyone else had this problem? Any possible solutions?

How do I do that exactly? Thanks

What are the advantages of the Pcut for me over the MH for the money?

I really need some help here. My old Roland Stika has died and I'm looking for a new cutter. I'm a hobbiest and cut mostly license plates, golf cart designs, mail box letters,etc. I really don't do anything fancy, maybe a two collor design on occasion. I'd like a bigger cutter then my 12" so, which cutter would be the best choice for me?

Does anyone use signblazer for simple design? I a hobbiest not a sign maker so I'm looking for a simple software to do both design and cutting. I had one that was great 10 years ago called DR Stika when I bought my Roland Stika. Now my stika has died and I'm looking at a bigger USCutter. I've played around with the demo of signblazer but I don't seem to be able to do even simple design and make it work. Any help would be greatly appreciated.

Thanks Guys!!!! What a great group here! Thanks Again!