EricDLS2003

Members
 View Profile  See their activity

  • Content Count

    4

  • Joined

  • Last visited

    Never

Community Reputation

0 Neutral

About EricDLS2003

  • Rank
    Newbie
  • Birthday 01/01/1

Profile Information

  • Gender
    Not Telling
  1. EricDLS2003
    Mark, I followed your instructions and got my first successful cut. Thanks for taking the time. Eric
  2. EricDLS2003
    Ok, I'll try and back it out further. I'm already at the lowest force setting. Thanks for the ideas
  3. EricDLS2003
    I tried that as well. Right now I have it at probably 1/32nd (visual guess). Do you think it has anything to do with the tension screw on the blade supporter?
  4. EricDLS2003
    So I just got a new Copam 2500. Went step by step through the user's manual. I did my first tests and the blade cut through the vinyl and backing. I tried various setting: Speed is at 10cm's, Force is 50, and offset at .25. I tried adjusting the blade to various heights and at one point put it where it was barely visible. I'm placing the blade holding into the supporter and even trying different tensions from firm to completely loose. What am I doing wrong? Anybody?