mh1351 arrived, setup was easy enough, test pattern cuts fine.
i have tried usb, parallel, and usb-serial adapter. following all steps outlined on these forums as to how to get them to work.
i cannot make the computer interface with the plotter. using the cables supplied and the supplied signcut x2 software,
and using the adapter cable, i have tried the usb-serial driver from both the dowloads on the website as well as the driver cd
which came with it, seperately and in conjunction with each other. software acts as though signal is fine (no errors) but yet
does nothing, with exception to frequently freezing forcing restart of the computer to correct it.
my computer does not have a serial port so i have not tried that.
this is very frustrating, hopefully you have some ideas for me