So I been reading the forums and was beginning to loose hope.
Butt, after some help from USCutter Tech support over the phone, we were able to figure out the problem.
Shout Out to Brandon! You the man!, [tell Irwin I said So! lol] thanks for the patience and Positive Energy.
After A few Software upgrades & Driver downloads we narrowed it down to the BAUD Speed on the machine.
It should be set to 9600 .
Mine was @ 19200, which was causing a long line to cut from end point to new begining point and freezing cutter on "Waiting".
I'm running A PowerBook G4 w/ Flexi Starter 8.5 for Mac.
A PCUT 630 w/ the provided USB cord.
So far a few Successful Runs!
