Junkman

Thank thats what I thought too.

Thanks. I was thinking maybe 20% over cost for materials plus $25 flat fee for setup and run and additional if they wanted me to install it. I would rather not install but will if asked.

I have a friend that wants a few signs for his business. One for the rear window of his truck simple lettering 10 inches high by 24 wide on white vinyl. The second is a 24inch tall by 8 foot long fo a box truck (same design just scaled up) Since I am new to this I want to be fair but still make a small profit or break even just to get my work out there. Any help or guidanc is appreciated. Joe

Is that a print job or vinyl?

Thanks you

I am going to run my LP24 off of my laptop for now and use the serial port to connect to the cutter. Is there a problem with using the USB for a mouse?

How did you request the samples?

I do a lot of work on motorcycles and small engines and I never thought of making gaskets with the cutter. For the prices the dealers chage for these things I may never buy another one again, I can buy a roll of gasket material for what one gasket costs. Thanks for the great idea and the setup info.

Thank you so much

Could someone make this cutable (minus the loop at the top) I am struggling. Thank you in advance for all of your assistance.

Thats ok I am just learning so I will give it a go. Thanks for the help

Im using signblazer I will try it out

Thank you very much. What do I use to clean it up?

thanks

When I convert a bitmap to monochrome and then vectorize it flips the image. Any suggestions or is this normal. Also how to I seperate the bitmap from the cutable image? Thanks

where can I get Inkscape?

ok thanks I will try that

try this Thumbsup.eps Thumbsup.eps

Thank you very much. Have you cut this before?

Can someone help and explain how to make this a cutable image and get rid of the choppyness please?

Thank you for your patience I am waiting for my cutter so I am just trying to learn as much as possible ahead of time. I am sure I will have tons more to ask when I finally receive it.

Thanks for the help. Now when I am ready to cut i can just import into SB and cut? That is where I get confused.

would like to vectorize this and also get some how to info. kawasaki_logo.eps kawasaki_logo.eps

Thank you

I created a logo and saved it as a .cdr file how can I convert it to .eps so I can make it cutable? Im lost please help me Thanks