miguelitox

man, i've been back and forth...trying all different kindsa combinations of these settings. nothing yet. been lookin through other posts, but nothing that looks promising yet. thanks for lookin around for me. mx

that's cool i suppose, the keyspan thing i mean, but i was cutting just fine going usb to the cutter from my mac for the past year. i don't want to buy more stuff if i don't have to, especially considering that i've paid for quite a few months of signcut subscription during which i haven't been able to cut at all.

says you. i updated everything, did the change over to to productivity pro, changed the cs4 plugin, and i'm still down. i can occasionally get the 'read cutter' button to work, but i've not been able to cut for months. i've scoured the boards for help on it, but the best i can get is that some people have gotten it to work but no one (that i've found) has posted the settings that made it work for them. im on snowleopard laserpointer 24 signcut productivity pro 1.07 illustrator cs4 cutter settings: /dev/cu.usbserial-0000201a baud: 9600 parity: non databits: 8 stopbits: 1 handshke: software checked RTS/DTR any help out there? please? someone? thanks mx

would you mind sharing your settings from the 'cutter' button? i'm still not able to cut and i can't figure this out. i got one job to go and now im stuck again. my setup worked just fine until my update to snow leopard. macbook 10.6 signcut 1.07 illustrator cs4 laserpoint 24 usb mac to cutter i'm set at /dev/cu.usbserial-0000201A 9600 baud/non parity 8 databits/1 stopbit handshake software rts/dtr checked thanks

i downloaded, updated and installed the illustrator plug in. i'm using cs4 on a macbook pro with 10.6.1. uscutter laserpoint 24. the plugin from illustrator takes me to signcut and the image comes up fine, but there's no communication with the cutter. any ideas on why? mx