-
Content Count
2,623 -
Joined
-
Last visited
-
Days Won
21
Content Type
Profiles
Forums
Gallery
Everything posted by mb20music
-
set the pressure to 80 and adjust the blade so that the blade sticks out a little more.
-
Can't you just cut vertically instead of horizontally on bigger jobs?
-
this is it right here click here
-
Brody Script is close - it comes with SignBlazer
-
you do your text then weld it then you can adjust spacing to how you want it.
-
very professional looking, nice job
-
Signblazer Elements Trial doesn't need a registration code as it never expires. Try this link here SB Elements
-
Oracal 631 is easily removeable and is very inexpensive. I think around $20 for a 24" x 10 yd roll.
-
Iron on material that does not require a heat press
mb20music replied to FasTech Design's topic in T-Shirts and/ or Garments
EnduraTex makes iron on vinyl, never used it but it is the only iron on vinyl I am aware of. I believe Signwarehouse carries it. -
x2
-
If your budget allows, get the Graphtec - you will not be disappointed. Plus it can cut letters down to 1/8" and the smallest the Copam will do is about 1/4" (depending on font).
-
I've always used my older blades for magnets, but go ahead and get some new blades they are pretty inexpensive and last a long time.
-
it will not stick to the machine, I have cut quite a bit of magnetic material just fine. You don't want to cut all the way thru, just enough so that you can bend the material and it will break off.
-
just have to bump up the pressure and adjust your blade so that it sticks out far enough to cut about half-way thru the magnetic material.
-
Problems with Tape and Vinyl
mb20music replied to psychoCutter's topic in Criticism and Complaints about USCutter
you need a high tack transfer tape for 631 -
for large quantities get them here at uscutter for smaller quantities purchase at Signwarehouse.com signwarehouse
-
http://www.dafont.com/mostwasted.font
-
what transfer vinyl are you using and what kind of fabric is the shirt?
-
Copam 4050 help needed
mb20music replied to born2boost's topic in Copam Cutting Plotter Support Requests
copam board