Kev C

All sorted!!! Just to say a huge thank you to both of you for your help. At least now I can run off the orders tomorrow and keep the customers happy!!!

Thanks, I've sent you a message through the forums.

Hi, Thanks for supplying the link, that's where I got the files from earlier today. I have tried unzipping them using a program called Free RAR Extract Frog, but the files can't be unpacked with the following message "....refused to be unpacked" and suggests the files might be corrupted. Do you have the file you could send me via e-mail? Thanks Kev

excellent, thanks. Do you know how to use the update file? I'm sure I did this on the previous version, just can't remember how. Thanks Kev

Using the installation disc for the Roland Drivers, I can't choose where to install them and already have them installed on my PC. Fortunately I have the machine working again and cutting well using the CoPam CP-2500 settings, but it's quite a bit slower then before. Could anyone still provide a link to an 'active' download for the signblazer version with all the cutters listed? or advice me on how to properly install the roland gx24 drivers so that I can select my cutter within signblazer? I've searched the web extensively and can't find anything here either. I did manage to download the patch and update .rar file, which I may have used on my previous version, but I can't remember how and what I used it for and whether this gives you all the cutters? Thanks for any help and assistance.

thanks again, Amazingly and I don't quite understand how, but using the CoPam CP-2500 as the listed cutter works with my Roland GX24. I'll try that if I have any further problems Thanks Kev

Hi, Thanks for your reply, The problem is I no longer have a 6.05 installer which I assume is the version with all the cutters? I've just checked the driver folder and it's empty, the only installer I have is version 6.01 btw, i do have the roland gx24 driver disc Any other ideas?

Hi all, I have been using signblazzer elements, the version with all the cutters installed, i believe this is the 6.05 version Today I tried to get rid of the annoying nag screens and counter, mine was up past 600!!! After following the very helpful you tube guide here I didn't realise the 6.01 version doesn't have all the cutters listed and I now cannot use my cutter as it isn't listed anymore. Could someone be soo kind as to let me know how I can get my Roland GX24 working again with signblazzer. Does someone have a link to a 'active' working download for the version I need with all the cutters listed? Any help and assistance would be greatly appreciated. Thanks Kev