bads31

hi dan. graham.

it was working and as i dont know what a good cutter is from a bad one that would be hard to do. it was going through ok then it started cutting everything instead of lifting. i have another small one that has worked fine not a clue if its good or not. there are so many people out there that say this and that are the best! i just want one thats reliable and cuts ok. so if you know any please advice. many thanks graham.

Sorry I did say it was an MT1351 as it states on the side in one of my first posts, so please could you tell me if would or wouldn't work. It does make sense with the static electricity, will definitely be doing that, thank you.

sorry to be thick, bottom of what board? as i have taken tje side panel of where the computer plugs in and cant see anything and if i order that part will it definatley fit my plotter? and what do you mean by grounded?

I have a Cutter Plotter MT1351, serial number: 2487 and it also has 'ROHS' on it next to the serial number. It's a 54". I started cutting earlier and as I was the cutter knife itself stop rising and stayed down wrecking the work I was doing at the moment. I have dismantled the top of the cutter had a play and put it back together and it still didn't work. Someone has said about it being the 'zchip' but I wasn't able to find it. A reply with help ASAP would be much appreciated as I NEED to get on with these jobs as they have a deadline and I NEED at least one done for Friday. All help will be appreciated very much.

would you be able to tell me where i can find the zchip on my cutter possible please? the serial number is 2487

sorry what is a zchip? its mounted on a stand as we speak. please can you tell me more please. thank u.

also ive noticed when you turn the plotter on the blade arm is meant to go up slightly but this is not? thank you for your reply.

i think its a mt1351. if that makes any sense.

hi please could some one help me. i have been given a cutter and ive managed to set it up with sign blazer. i started cutting a few things off and have noticed that it is cutting all of the plotting lines instead of lifting and moving to the next piece. ive put the blade in and it is just sticking out of the holder but is very close to the cutter top. as it moves it doesn't move up and down it stays at the same point. please can anyone shed some light on this please. many thanks.