Have a new Laserpoint 24, everything works just fine cutting with SignBlazer but thought I'd take a look at Signcut X2.
Installed no problem, have all of the plotter settings set up (as far as I can tell) the same way I do in SignBlazer... knife is zeroed at the right edge of the vinyl... but everytime I go to cut it backfeeds all of the vinyl back out of the plotter and moves the head into the righthand limit switch.
Have even tried leaving a few feet of vinyl hanging out the front and zeroing the cutter close to the lefthand side for kicks... same thing... all the vinyl backfeeds out of the plotter and the head zips over until it hits the limit switch on the right.
I know it has to be something with the software, because the cutter works fine with SignBlazer... but I've checked every setting I can think of checking.
FWIW even imported the same .EPS into Signcut as I did into SignBlazer so even that *should* be a constant.
Any ideas what I'm missing?
Thanks!
>>>>> Mike <<<<<