randyb

I have a mh 721 that i have used for years on my computer with windows XP. I moved it to a buddys house and cant get it recognized on his computer with windows 7. I am using a keyspan adapter to go from serial port on printer to USB on computer.The keyspan adapter is installed and recogniized . Any help is greatly appreciated.

I have the Tripp lite keyspan adapter, been using it for years because the USB port broke on the printer end. I moved the machine to a different house and computer with Windows 7

Signblazer, the problem is it's not recognized in device manager

Signblazer, the problem is it's not recognized in device manager, When the printer is plugged into the keyspan , nothing happens?

I am looking for some light grey -air release vinyl? Anybody ever see any?

I only have a 54inch cutter

Can anybody tell me what FONT this is??

Looking for some orange fluorescent vinyl. 15 inches by 30 inches? Sign vinyl

Sorry i posted in the wrong section.

15 inches by 30 inches Sign vinyl

What do you guys recommend for transfer tape when using Oracal 651,used on race cars I am thinking about trying the new RTape Clear Choice AT75

How much memory does the SC series have?

Anybody turn this into single layer? .eps format

Anybody turn this into single layer? .eps format

Looking for a Tasmanian devil in eps format?

Since static electricity is such a problem, .esp with the MH series that dont have wires going directly to the blade. I have noticed on the TC model there is wires directly in the blade holder?From what i can see in pictures? Anybody ever try to attach a ground wire to the blade holder on a MH series and then go the stand or somewhere?

Yes my MH has the ground wore from the base of the cuter to the stand.But i still have trouble and thinking of a better way to ground? The motherboard is not attached to the cutter so i am not sure if it is grounded or if it would make a difference?The motherboard is attached with plastic clips so it does not contact metal. I was just wondering if adding a ground from the cutter holder to the base or maybe even right to the motherboard? What you all think????

Updating my MH-721 What do you guys recommand,creation P-cut or maybe a uscutter TC model? $500 budget

I dont have $1,800 for the Roland GX24

I been having trouble with my MH-721 not finishing cuts and sometimes i hit 'SEND' to cut my vinyl and nothing happens.Sometimes it says CONNOT open port, others just nothing happens and i have to restart my computer and i can make a few more cuts.I can never make more than 3 cuts without having to restart my computer. I finally got a KEYSPAN to work with a new NULL serial cable but it did not change a thing. I am using us cutter mh-721 drivers on a computer with XP, also tried 2 different computers so i dont think it the computer? I do not have it on carpet and i have grounded the stand, could it be motherboard and/or memory problem?

I have decided to update from my MH-721 cutter What do you recommend for a budget of $500 I mainly do race car graphics. I was looking at the TC model? Would my stand work and would my blade work since i just bought a clean cut blade? Any advise is greatly appreciated.

Updating my MH-721 What do you guys recommand,creation P-cut or maybe a uscutter TC model? $500 budget

Thanks again , I do turn my machine off when not in use.If thats what you mean, but i do not turn it off after every 1 cut? I just talked to a buddy and we are thinking of updating, i am going to post a new thread. Thank you again !!!!!!!!!!!!

I will try and turn off the machine after every cut. Thanks Mz SKEETER!!!!!!!!!!!!!

I have 3 serial cables but they are all straight pass through cables. I need a cross through NULL cable. When these cables are advertised they advertise them as DB( NULL cables) Please help me get the correct cable.... I also saw where there a wiring diagram that showed they pin location of each pin but it only showed pins 1-7 ?