I dont mean to bring old topics into play however I have gone through hell and back over this issue. LXi does not play nice with USCutter.csm they have stripped out the USCutter.csm from flexi during installation. I know this because I watched it going in and found it missing after. I tried uninstalling and reinstalling so I could copy it before it was erased by the install however even that one will not work and you are forced to go to the oem for your USCutter machine. Example the SC series is actually a LiYu cut, My zen green is actually a GCC Puma3s. I tried the Puma3s drivers that come loaded in LXi and no JoY the cutter would peter out llike there was a static issue or something. I tried loading newer drivers from GCC whom swore they would work and still no JoY.
In the end and in my case I was forced to do a dirty hack to make my machine recognizable. By that I mean I had to download a firmware version of the Puma3 and flash my firmware. This is admittedly not a preffered way to go however no one had any solid answers and signwarehouse has the worst CS in the trade so they are no help at all. This was over the head of most CS reps though and IN NO WAY RECOMMENDED. If you fry your mobo it is 450. new or 150. refurbed so if and before you guys get any crazy ideas think about that first. I have a lot of programming and IT background or I would not have done it and again I do not recommend this as a solution. This is only an example of critical thinking and desperacy as well as how much trouble this program can cause. I highly recommend FLEXI over LXi if you can afford it. LXi is pretty much the same program however it does not play nice with all Cutters.
